2022 Mazda CX‑5 · U‑Haul

Towing to Hood River

Don’t book an unbraked trailer until Mazda confirms the brake limit for this CX‑5. If you can’t get a clear answer, ship the extra load or rent a moving truck.

Before renting

Ask Mazda about the brake limit.

The 4×8 is the only enclosed U‑Haul I’d pursue with this Mazda, and only for a light load. The 5×8 is heavier and has no brakes. Don’t accept a 6×12 as a substitute: the enclosed one has brakes but weighs about 1,920 lb empty.

Ask Mazda this exact question.

“For a U.S. 2022 CX‑5, does the 1,000 lb threshold for trailer brakes apply only to the trailer and its cargo? Or does it also count the hitch, passengers and gear in the car?”

The manual uses the same term in both places. The weight section includes the hitch, passengers and gear. Until Mazda confirms what it means in the brake section, don’t count on the 4×8.

Mazda USA · 800‑222‑5500 Read the manual

4×8 enclosed

850 lb empty, no brakes

On a trailer-only reading, 150 lb is the most you could add before other limits. The 77 lb bike leaves roughly 73 lb on paper for everything else, including restraints, before leaving a margin.

5×8 enclosed

900 lb empty, no brakes

On the same reading, the bike leaves roughly 23 lb on paper. That makes it a poor choice for the bike and boxes.

Ask the Tucson U‑Haul to confirm the exact trailer and hitch. Confirm that the one-way contract lists the return in The Dalles. U‑Haul can approve its rental without settling Mazda’s limits. If the numbers don’t work, carry the extra load another way.

U‑Haul trailer weights · Which models have brakes

At home

Put the bike down the middle. Put dense boxes low.

The 4×8 has a listed rear opening of 41 in wide × 46 in high. The Globe Haul ST handlebars can reach 46.9 in at their highest setting. Measure the bike with its accessories and the actual trailer opening. Ask the rental shop for a non-slip ramp rated for the bike and approved for the trailer. Confirm the anchor points and ramp before paying. Walk the bike in; don’t ride it or improvise a ramp.

Top view · where things go
HITCH / CAR Axle Denseboxes Wheel block Lightbags REAR DOOR

Keep the bike upright along the centerline. Match dense boxes left to right. Use the real tie-down points; dashed lines show directions only.

Side view · keep weight low
HitchRear door Axle Bike upright Keep dense boxes on the floor.

The axle is the line between the trailer wheels. Start with the heavy part of the load just toward the hitch from that line. Adjust it only after measuring the load. The axle and anchor locations vary by trailer.

  1. Roll the bike in first. One person holds it upright. The other sets the wheel block and restrains the bike to tie-down points the rental shop approves. Use rated straps and a compatible holder if needed. The kickstand and bike brakes won’t hold it in transit. Keep straps off cables, fenders and controls.
  2. Place boxes around the bike. Put dense boxes on the floor, just forward of the axle and balanced left to right. Put light bags near the door only if the measured balance allows it. Secure every piece separately so it can’t slide, tip or hit the bike. Aim for about 60% of the cargo weight in the front half.
  3. Weigh the trailer and the hitch load. Tongue weight is the downward force on the hitch ball. Mazda asks for 10–15% of the weight of the trailer and its cargo. For example, a 950 lb trailer would need about 95–143 lb on the ball, if Mazda and U‑Haul approve the setup. The actual hitch, vehicle and axle limits still apply.
  4. Shift, secure and weigh again. If the hitch load is too low, move a dense pair slightly forward. If it’s too high, move the pair slightly back without making the rear heavy. Retie what moved and weigh again. If you can’t meet the targets together, take cargo out.

Load on level ground with the trailer still hitched. Put the car in Park and set the parking brake. Chock the wheels against rolling. Before rental day, identify a scale and ask the rental staff to show you how to measure the hitch load.

Pickup and driving

Check the hitch together before you leave.

Slow before a long descent

On a dry road, pick a lower gear before the grade and let the engine help hold your speed. If speed creeps up, brake below your target and release the pedal. Don’t ride the brakes. Mazda warns against engine braking at high speed or on slippery roads.

Ease off if the trailer sways

Ease off the accelerator and steer straight. Don’t use the brakes or jerk the wheel to correct sway. Once the rig settles, pull over safely. Check for a shifted load or other cause before continuing.

U‑Haul trailer instructions · Mazda towing tips

Route choice

Choose the pass with the clearest weather.

California has the lowest summit of these three routes. It also has two long downhill grades. If the roads are clear, I’d take I‑5 and cross the Grapevine and Siskiyou in daylight. Overnight in Santa Clarita, then Redding. It’s roughly 500, 470, and 490 miles per day, or nearly nine hours of driving per day at 55 mph before stops. Add a night if delays push a descent into the dark. Check roads before leaving each morning. Mazda also reduces allowable load at higher elevations, so confirm the route when you ask about weight limits.

Steep gradeWinter exposureWind exposureCurves / two-lane
Route map · schematic
Elevation over distance · approximate

Lines connect selected elevation landmarks at approximate road miles. Use the triangles to find stretches worth checking. The map is schematic and the weather flags are not live.

Firsthand accounts

What other CX‑5 drivers noticed

These drivers reported their own experiences. They didn’t test emergency stops, and several towed above Mazda’s limits. Use their accounts to plan the packing and the drive, not to decide what the car can safely tow.

What I’d borrow: Tape out the 4×8 floor at home to check fit. Weigh the bike and boxes separately. Leave room in the schedule for slow grades, and judge the route by the descents as much as the climbs.